I. Profile Drawing:

II、Process flow:

Passive uncoiling → Rolling forming (Including guided feed) → Length cutting → Discharge table.

III、Components of the Machine Line:

1. Uncoiler:

(1)   Uncoiler: Passive feeding, manual expansion

(2)   Loading Weight : 3 T

(3)   Uncoiler Coil I. D : 508mm

(4)   Rolling range : 450-540mm

2. Forming Machine:

(1)    Main frame: High quality steel after welding and tempering

(2)   Forming machine type : Wall plate chain drive

(3)   Shaft material: 40Cr

(4)   Shaft diameter : Φ60 (HRB Bearing)

(5) Motor power : 7.5 KW (Hardened surface reducer)

(6)   Forming machine line speed: 0-20 m\min (excluding cut-off time)

(7)   Roller way nos : 14 nos

(8)   Rolling thickness : (0.6 -1.2) mm

(9) Expanded width of rolled material: The actual width of the test plate shall prevail

(10) Length accuracy. : ±1 mm

(11) Roll material: Gcr15

(12) Roll hard chromium plating acuity  : 0.05 mm

3. Hydraulic cutting mechanism:

(1)   Cutting type：hydraulic cutting off after forming

(2)   Cutting blades ：1 set

(3)   Forming cut type material : Cr12M0V

(4)   Motor power of hydraulic station: 4 KW

(5)   Hydraulic station oil pump: vane pump

4. Unloading table :

(1)  Unloading table size : 2000mm * 2 pcs

(2) Unloading table structure: Roller structure, angle steel welding, no power.

IV. Equipment structure:

The main machine is composed of Passive Uncoiler roller forming (Including guide feeding, hydraulic cutting mechanism), unloading table, hydraulic system, electronic control system, etc.

V. Machine Picture: